Canon IJM663 Scrim Banner Light, Matt M1 325g/m² 97001289 2200mm x 50m roll **LATEX / UV (GEL) / (ECO) SOLVENT**

Other available sizes

Canon | IJM663 | Scrim Banner Light, Matt M1 325g/m² | 97377456 | 900mm x 25m roll

Canon | IJM663 | Scrim Banner Light, Matt M1 325g/m² | 97002635 | 900mm x 50m roll

Canon | IJM663 | Scrim Banner Light, Matt M1 325g/m² | 97377271 | 1100mm x 25m roll

Canon | IJM663 | Scrim Banner Light, Matt M1 325g/m² | 97377268 | 53" 1350mm x 25m roll

Canon | IJM663 | Scrim Banner Light, Matt M1 325g/m² | 97377213 | 63" 1600mm x 25m roll

Canon | IJM663 | Scrim Banner Light, Matt M1 325g/m² | 97001289 | 2200mm x 50m roll

Printing Guidelines

Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. Make sure that the media comes not into contact with grease, oil, silicon, and dirt to avoid printing defects.

Load the media with care in the printers. Incorrect loading can cause skewing or creasing. Use a take- up device to prevent wrinkling.

It is recommended to calibrate the printer before printing and to make a test print. Print results will vary for different printer/ink combinations. Canon media profiles include recommended settings for ink restrictions and printer parameters.

Depending on fluctuations in environment, printer, ink, media and applications, printer parameters may have to be adjusted slightly, in order to obtain the best results.

For high-speed production printing, using an external drying unit is recommended.

The coating of IJM663 is especially developed for digital inkjet printing. However IJM663 also can be screen-printed. It is recommended to do a test on a small area, because every machine and ink can have different properties.

Fibres of the scrim may fray at edges of the banner. Remove frays or use edge guides for preventing fibres touching the printheads. Frays can be removed by fire, using a gaslighter or torch.

Application Guidelines

Avoid folding a printed banner. Hard creases may not flatten out during installations. When used for banners or other hanging applications, hemming the edges is recommended. Standard high-tack banner tape can be used as well as sewing.

If sewn, it is recommended that the banners are stitched hem side up so that the sewing machine comes into contact only with the reverse surface of the banner. When applying grommets, they should be inserted in double-hemmed edges. Corner grommets should be placed where the length and width hems cross, so that the grommet goes through four layers.

For the manufacture of large surface area posters, individual lengths are overlapped by 2-3 cm and best joined up by means of a high frequency welding system. However, such overlap seam welding can also be carried out by means of a hot air welding unit.