Canon IJM579 Polyweave Heavy B1 235g/m² 97003844 60" 1524mm x 30m roll **CRYSTAL POINT / WATER-BASED / LATEX INKS**

Other available sizes

Canon | IJM579 | Polyweave Heavy B1 235g/m² | 97003841 | 24" 610mm x 30m roll

Canon | IJM579 | Polyweave Heavy B1 235g/m² | 97003842 | 36" 914mm x 30m roll

Canon | IJM579 | Polyweave Heavy B1 235g/m² | 97003843 | 42" 1067mm x 30m roll

Canon | IJM579 | Polyweave Heavy B1 235g/m² | 97003844 | 60" 1524mm x 30m roll

Printing Guidelines

Side to be printed is the outer side of the roll. Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. It is recommended to calibrate the printer before printing and to make a test print. Textiles tend to crease when fed through printers.

For minimizing creasing and prevent risk on head-strikes always use the take-up unit of the printer. Increasing the printhead height adjustment will minimize the risk on head-strikes. To optimize print quality, print-mode should be set for highest print quality. Ink restrictions and printer settings have to be set for specific printer ink combinations to obtain the best results.

Canon media profiles include recommended ink restrictions and printer parameters. Depending on environment and application, printer parameters may have to be adjusted slightly in order to obtain the best results.

Application Guidelines

Allowing the prints to dry at least 24 hours before finishing is strongly advised. When using for banners or other hanging applications, hemming the edges is recommended. When applying grommets, they should be inserted in double- hemmed edges. Corner grommets should be placed where the length and width hems cross, so that the grommet goes through four layers.

Using glue or pressure sensitive adhesives is not recommended, as this does not prevent the material from natural environmental shrinkage over time. When you use a “hot-knife” to cut this textile, there will be no fraying.