Canon 2345C Water Resistant Self-adhesive Matte PP Film 290g/m² 97005349 36" 914mm x 20.5m roll

Other available sizes

Canon | 2345C | Water Resistant Self-adhesive Matte PP Film 290g/m² | 97005350 | 24" 610mm x 20.5m roll

Canon | 2345C | Water Resistant Self-adhesive Matte PP Film 290g/m² | 97005349 | 36" 914mm x 20.5m roll

Canon | 2345C | Water Resistant Self-adhesive Matte PP Film 290g/m² | 97005348 | 42" 1067mm x 20.5m roll

Printing Guidelines

Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. Make sure that the media comes not into contact with grease, oil, silicon, and dirt to avoid printing defects. Insert the paper with care in the printer.

Incorrect loading can cause skewing or creasing. It is recommended to calibrate the printer before printing and to make a test print. Print results will vary for different printer ink combinations. Ink restrictions and printer settings have to be set for specific printer-ink combinations to obtain the best results.

Canon media profiles will set recommended ink restrictions and printer settings for Canon supported printers. Recommended media settings on Canon printers: Operation Panel: WatRes Adh MatPP Printer Driver: Canon WaterResistant Adh MattePP

Application Guidelines

This material is developed for both dye-based and pigmented inks. Image durability with dye- based inks will vary depending upon use and exposure to light and UV radiation. The use of pigmented inks will establish excellent indoor and outdoor longevity up to many months (dependent on exposure conditions).

After printing allow at least 4 hrs of drying to obtain the outdoor water resistance. The material will stick to any even and smooth surfaces which are dry and free of dirt, grease, silicon etc. except nonpolar surfaces like PE and PP. Before glueing it is recommended to check that the surface is appropriate for this aim and that it has been prepared (cleaned) professionally.

When applying the film, the surface temperature should not be below 15 °C. The media can be used outdoor without lamination when printed. However, we recommend protecting its surface if it is subject to abrasion or any other mechanical influences, to dirt or humidity.

When dye inks are used, we recommend to always laminate the film to improve the lightfastness and to protect it against smudging. The film can be removed by heating the surface of the film with a hot air gun. Then pull it off carefully.