Canon IJM673 Scrim Banner Blockout B1 610g/m² 97002756 2200mm x 30m roll **LATEX / UV (GEL) / (ECO) SOLVENT**

Canon | IJM673 | Scrim Banner Blockout B1 610g/m² | 97002753 | 1100mm x 25m roll

Canon | IJM673 | Scrim Banner Blockout B1 610g/m² | 97002754 | 54" 1370mm x 25m roll

Canon | IJM673 | Scrim Banner Blockout B1 610g/m² | 97002755 | 63" 1600mm x 25m roll

Canon | IJM673 | Scrim Banner Blockout B1 610g/m² | 97002756 | 2200mm x 30m roll

Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. Make sure that the media comes not into contact with grease, oil, silicon, and dirt to avoid printing defects. Load the media with care in the printers. Incorrect loading can cause skewing or creasing. Use a take- up device to prevent wrinkling.

It is recommended to calibrate the printer before printing and to make a test print. Print results will vary for different printer/ink combinations. Canon media profiles include recommended settings for ink restrictions and printer parameters. Depending on fluctuations in environment, printer, ink, media and applications, printer parameters may have to be adjusted slightly, in order to obtain the best results.

For high-speed production printing, using an external drying unit is recommended. For double-sided printing follow the printer instruction-manual carefully. Fibres of the scrim may fray at edges of the banner. Remove frays or use edge guides for preventing fibres touching the printheads. Frays can be removed by fire, using a gaslighter or torch

Avoid folding a printed banner. Hard creases may not flatten out during installations. When used for banners or other hanging applications, hemming the edges is recommended. Standard high-tack banner tape as well as sewing, can be used for hemming. If sewn, it is recommended that the banners are stitched hem-side up, so that the sewing machine comes into contact only with the reverse surface of the banner.

When applying grommets, they should be inserted in double-hemmed edges. Corner grommets should be placed where the length- and width-hems cross, so that the grommet goes through four layers.

For the manufacture of large surface area posters, individual lengths are overlapped by 2-3 cm and best joined up by means of a high frequency welding system. However, such overlap seam welding can also be carried out by means of a hot air welding unit.