Canon IJM645 Polymeric Vinyl Gloss, Grey Permanent 80mic 97004320 63" 1600mm x 50m roll **LATEX / UV (GEL) / (ECO) SOLVENT**

Canon | IJM645 | Polymeric Vinyl Gloss, Grey Permanent 80mic | 97004319 | 54" 1370mm x 50m roll

Canon | IJM645 | Polymeric Vinyl Gloss, Grey Permanent 80mic | 97004320 | 63" 1600mm x 50m roll

Canon | IJM645 | Polymeric Vinyl Gloss, Grey Permanent 80mic | 97005204 | 63" 1600mm x 100m roll

Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. Make sure that the media comes not into contact with grease, oil, silicon, and dirt to avoid printing defects. Insert the film with care in the printer. Incorrect loading can cause skewing or creasing.

It is recommended to calibrate the printer before printing and to make a test print. Print results will vary for different printer ink combinations. Canon media profiles include recommended settings for ink restrictions and printer parameters. Depending on environment and application, printer parameters may have to be adjusted slightly in order to obtain the best results.

Optimal bonding properties are obtained on smooth and flat, dirt-and grease-free surfaces Fresh lacquered surfaces should not be used for the application of the vinyl foil. Pre-testing the adhesive onto unknown surfaces is strongly advised. When applying the vinyl temperature should be higher as Application temperature range from -40°C to +90°C.

IJM645 can be used outdoor without lamination. However, we recommend protecting the vinyl if is subject to mechanical abrasion. Lamination protects against UV and improves contrast and colour brilliance. Let the prints dry for at least 48hr before laminating it. Use only pressure sensitive laminates. For removal we recommend to start with one corner and slowly peel off the surface with a 60° 90° peel angle. It may be helpful to use a hot-air blower but this must be used with caution to avoid surface damage.