Canon LFM331 Tyvek 105g/m² 97004165 36" 914mm x 50m roll **CRYSTAL POINT / UV Gel (MATTE ONLY)**

Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. Make sure that the media comes not into contact with grease, oil, silicon, and dirt to avoid printing defects. Insert the Tyvek with care in the printer. Incorrect loading can cause skewing or creasing. It is recommended to calibrate the printer before printing and to make a test print.

Print results will vary for different printer ink/toner combinations. Ink/toner restrictions and printer settings have to be set for specific printer-ink/toner combinations to obtain the best results. Canon colour profiles will set optimal restrictions and printer-settings for Canon supported printers. Because of the random/non oriented fibers Tyvek has a certain inhomogeneity across its web.

This inhomogeneity may differ per batch and may lead to problems on printers, specifically in cases where Tyvek is exposed to heat. Due to the nature of the product, high tolerance on thickness, only CW700 and CW3700 are recommended.

Pressure-sensitive adhesive tabs of Tyvek® or Mylar® polyester film wrapped around a sewn seam at each edge will reduce the possibility of edge tear. It is recommended that the Tyvek banners are stitched hem side up so that the sewing machine comes only in contact with the unprinted side of the banner. Use 1.2 to 2 stitches/cm at low tension to eliminate skipping.

When sewing banners, avoid stitches at or near the edge to reduce the chance for edge-tear. When applying grommets, they should be inserted in double hemmed edges. Corner grommets should be placed where the length and width hems cross, so that the grommet is embedded in four layers.