Canon IJM627 White Outdoor Paper Gloss (FSC) 200g/m² 97345534 63" 1600mm x 50m roll **SOLVENT / (UV)gel / LATEX**

Canon | IJM627 | White Outdoor Paper Gloss (FSC) 200g/m² | 97345316 | 42" 1067mm x 50m roll

Canon | IJM627 | White Outdoor Paper Gloss (FSC) 200g/m² | 97345344 | 50" 1270mm x 50m roll

Canon | IJM627 | White Outdoor Paper Gloss (FSC) 200g/m² | 97345534 | 54" 1372mm x 50m roll

Canon | IJM627 | White Outdoor Paper Gloss (FSC) 200g/m² | 97345969 | 63" 1600mm x 50m roll

Allow material to adapt to room conditions for 24 hours before printing. It is recommended to handle the media with cotton gloves. Make sure that the media comes not into contact with grease, oil, silicon, and dirt to avoid printing defects. Load the media with care in the printers. Incorrect loading can cause skewing or creasing.

Use a take- up device is recommended. It is recommended to calibrate the printer before printing and to make a test print. Print results will vary for different printer/ink combinations. The ink limit, i.e. the maximum amount of ink, should be adjusted depending on the printer, ink, RIP software. This limitation of the amount of ink shortens the drying time and consequently accelerates the production process.

Canon media profiles include recommended settings for ink restrictions and printer parameters. Depending on fluctuations in environment, printer, ink, media and applications, printer parameters may have to be adjusted slightly, in order to obtain the best results. For high-speed production printing, using an external drying unit is recommended.

This paper can be pasted as a billboard paper. The most important criteria is the right preparation of the billboard poster. After wetting the wet paper should be put air tight into a plastic bag (or into a box). It is important that IJM627 prints have the possibility to soak through completely before pasting. We recommend to keep the IJM627 Paper wet for at least eight hours. Longer periods of time don’t have any negative impact on the paper.

The user is responsible for appropriate microbiological precautions. Many standard pastes can be used, Henkel UST 2500N Zellura adhesive has been tested. Overlapping should be carried out with enough glue on the overlapped printed part. It is advisable to protect the edges and corners if the billboard hoarding is regularly cleaned. Water resistant wood glue can be added for better adhesive strength. Additives like anti- freeze (e.g. glycols) will have a negative effect on the final pasted image.

The “wet” pasting method is not recommended for prints with UVgel/UV inks. Use the dry pasting method instead: apply the glue on the back of a dry print and on the billboard. Wait for a few minutes and then apply the print billboard. Applying glue on the front of the poster is not recommended, as this may result in damage to the print. Starch-based glues can be used.

Some well-known glues in this category are: Henkel Zellura and Avebe Solvicol. In the event that the paper is exposed to severe climatic conditions, or if it needs to be used for a longer period (> 3 months) of time, lamination is recommended.